Important Advice; Using Your Appliance - Krups 7000 Serie Manual De Instrucciones

Description of the blender
A Metal base
B Speed selection panel
b1 – Stop button
b2 – Slow speed
b3 – speed 1
b4 – speed 2
b5 – speed 3
b6 – speed 4
b7 – Ice crush function
b8 – Vari-Pulse function
C Cord tidy cavity
D Blender jug assembly
d1 Locking ring base
d2 Removable blade carrier
d3 Seal
d4 Graduated 1.75-l glass jug
E Blender jug cover
F Measuring stopper, 75 ml
G Grinder accessory depending on model

Important advice

Important: Ensure that the blender cover (E) with measuring stopper (F) are correctly fitted on the blender
jug (D).
- Never start the appliance on its highest speed.
- Always increase speed progressively.
- Remove the blender jug or accessory from the motor unit only when it has come to a standstill.
- For greater convenience or storage, the length of the supply cord can be reduced by pushing it into the
metal base (A) through the opening at the rear (C) (diagram 1).

Using your appliance

- Before use, clean the blender jug, the cover, the measuring stopper and the grinder accessory in warm
soapy water. Rinse and dry them carefully.
1. USING THE BLENDER
The capacity of the jug allows you great freedom in your preparations. Furthermore, as it is made of glass
you can make a variety of ice-based preparations in complete safety.
1/ Place the ring seal (d3) in position over the base of the removable blade carrier (d2) (diagram 2).
2/ Clip the assembly (d2 + d3) into the locking ring base (d1).
3/ Place this assembly under the glass jug (d4), taking care to fit the hemispheres on the lower part of the
jug (d4) into the seatings in the base (d1) (diagram 3).
4/ Lock the base in position by giving it a quarter turn.
- Place the assembled blender jug (D) on the metal base (A). There are two possible positions with the
handle to the left or the right of the speed selection panel (B).
-For your own safety, the blender will not start unless it is correctly assembled and positioned on the metal
base (A).
10