Disinfection; Recicling The Batteries; Authorized Repair Service - AngelSounds ASOUNDS-C Manual De Instrucciones

- Do not immerse the device. Keep the exterior surface clean and free from dirt and dust with a soft
cloth soaked in soap solution, and dry immediately with a dry cloth. Remove any remaining gel from
the transducer with a soft cloth and neutral soap.
- Soak the cloth before cleaning.
- Do not allow fluids to penetrate the equipment.
- Avoid using cloths or materials that may scratch the equipment.

4.5 Disinfection

Clean the surface of the main unit and the transducer with the above mentioned solutions. Then,
wipe the transducer surface with 70% ethanol or alcohol. Dry with a soft cloth.
CAUTION: Do not use low-temperature steam or other high temperature methods to sterili
ze the device.

4.6 Recicling the batteries

The batteries supported by this product are recyclable. Remove the old battery from the device and
follow your local recycling regulations
WARNING: irregular treatment of batteries may cause damage to health and environment.

4.7 Authorized repair service

This product does not incorporate internal components for technical maintenance. Try to solve any
technical problem with the troubleshooting table presented above. If you cannot solve the problem,
contact the Jumper Medical Equipment Co., LTD customer service department.
NOTE: the warranty will be void upon unauthorized disassembly or service of the equip
ment.
Section 5: Specifications and safety
EThis section presents the specifications and safety standards of the product.
5.1 Specifications
NOTE: The following specifications are subject to change and are only a point of reference.
ULTRASOUNDS
Ultrasonic emitting frequency:
Ultrasonic emitting power:
Overall sensitivity at a distance of 200mm from the transducer plate
(Doppler frequency: 300±50H<, target velocity: 10 cm/s~40cm/s)
Spatial and temporal peak acoustic pressure:
Output power
Effective area of the ultrasonic transducer active element
Acoustic coupling medium for normal use
A S
22
3MHZ
<10mW/cm2
≥90dB
<8.6kPa
<26mW
5.3cm2±20%
ph:5.5~8, Acoustic impedance:
1.5*10 ~1.7*10 Pa · s/m
6 6