Pentair STA-RITE VSD Serie Manual De Instrucciones página 12

EN
DISPLAY
I N I B I T I N P U T
If the installation does not have a minimum level sensor press the button
N O
validate NO.
If the installation has a level sensor, use the buttons
P R O G R A M M I N G M E N U
S E T P R E S S U R E
3 , 5
value (2 bar).
ATTENTION! The required pressure should be 1 bar below the maximum pressure of the
pump.
NOTE: In the case of pressure group installation, this work at the required
The default value is 0 bar. This pressure is what the system will subtract from the required
D I F . S T A R T .
0 , 6 b a r
value. It is advisable to keep this value between 0.3 and 0.6 bar. Example:
- Required pressure PRIC: 2 bar.
- Start-up differential 0.6 bar
The differential value must be greater the lower the volume of the expansion vessel is.
The default SLEEP TIMER is 5". This will be used by the device to stop once the water
T I M E R S T O P
5 s
initial value.
There are 2 screen options to choose from:
V I E W M O D E
-STANDARD: "P LAV" (actual pressure of installation) and "P RIC" (pressure of work required)
S t a n d a r d
The default value is "SLAVE".
S E R I A L C O N T R O L
S l a v e
In the case of Group installation (MASTER-SLAVE), the device to be designated
option to "master" by pressing the button
P L I N E P S E T
Press the
2 , 2 b a r 3 , 5 b a r
ously chosen. Press the button
In the case of group assembly press
IN MASTER & SLAVE MODE.
ON / OFF button in the MASTER device, the
work, examine the connection (Fig.6a, 6b or 6c).
18
DESCRIPTION BUTTON
ENTER to
ENTER
ENTER
to change the initial
ENTER
to change the initial
ENTER
to change the
ENTER
ENTER
ENTER.
ENTER
.
-
or AUT LED of the SLAVE
DISPLAY IN AUTOMATIC MODE
P L I N E P S E T
0 , 0 b a r 3 , 0 b a r
Standard
H z P S E T P L I N E F L
2 , 3 1
5 0 3 , 0 b a r
Service
I P U M P T E M P .
2 0 º C
4 , 1 A
Current and temperature
FUNCTIONS AND ALARMS REGISTERS
I
use the button
+ 5 s
R U N N I N G T I M E R E G I S T E R
H O U R S 1 2 6 C Y C L E
P L I N E P S E T
0 , 0 b a r 3 , 0 b a r
A L A R M C O U N T . A L A R M C O U N T .
D R Y R U N 2 0 O V E R T E M P .
MAX PRESSURE The maximum pressure reached in the installation. It detects water hammer.
CONTACTOR OVERCURRENT ALARM. Number of alarms due to overcurrent.
CONTACTOR OVER TEMP. ALARM Number of alarms due to overheating.
CHAPTER 6
MAINTENANCE
MENU +
R E G I S T E R M A X P R E S S U R E
8 4 2 5 P O W E R O N 1 8 2 5 0 , 0 b a r
A L A R M C O U N T . A L A R M C O U N T .
0 0 O V E R C U R R . 0 0 S H O R T C I R C . 0
EN
0
19