Left-handed DJI Focus Remote Controller users could insert sliding rod from the opposite side for left-handed
positioning.
1. Pull the securing knob to release the sliding rod.
2. Remove the allen key screws on the DJI Remote Controller Focus Mount (below) and adjust the lanyard
balancing mount accordingly. Tighten the screws when ready.
3. Insert the sliding rod in from the opposite side of the DJI Remote Controller Accessories Mount. Lock the
sliding rod position by tightening the tension adjustment knob.
A
B
4. After adjustment, the whole set is shown as below.
It is recommended to leave the DJI Remote Controller Accessories Mount on the rear of Remote
Controller. Frequent installation and removal will reduce the service life of DJI Remote Controller
mounting screws.
DJI Remote Controller Mounting Screws should be pulled up when loosened. Pull the Securing knob to
detach the DJI Remote Controller Accessories mount and the sliding rod.
Get the extra DJI Remote Controller Accessories Mount and the DJI Remote Controller Mounting
Screws separately on the official DJI Store.
To allow communication between the two devices, connect the communication port on the Focus
Remote Controller to the Remote Controller using the DJI Focus -Remote Controller CAN Bus cable or
the 5.8GHz Focus Expansion Module when used wirelessly.
This content is subject to change.
Download the latest version from
http://www.dji.com/product/focus
Copyright © 2016 DJI All Rights Reserved.
A