Headset Mode - Husqvarna X-COM R HP310-1, X-COM R HP310-2 Manual De Usuario

1. Connect the charger cable to the outlet on the left
earmuff. (Fig. 26)
2. Connect the USB connector on the charger cable to
a USB charger or computer USB port. A beep sound
tells you that the product charges.
3. Charge the product for a minimum of 4 hours to get
maximum battery capacity. If you charge the product
for 1 hour, you get 8 hours of operation.
To start the product
Note: The product always starts in FM radio mode.
1. Push and hold the On/Off/Mode button for 3
seconds.
2. Audio messages tell you about the status of the
product. Refer to the table below.
Audio mes- Information
sage
POWER ON The product is on.
BATTERY The battery is full.
LEVEL FULL
BATTERY The charge level of the battery.
LEVEL 75%,
BATTERY
LEVEL 50%,
BATTERY
LEVEL 25%
BATTERY The charge level of the battery is low.
LEVEL LOW
RADIO The product is in FM radio mode.
CONNECTED The product is connected to a device
Bluetooth
with
To change between FM radio mode and

Headset mode

1. Push the On/Off/Mode button for 1 second to change
between FM Radio mode and Headset mode.
2. Audio messages tell you about the status of the
product. Refer to the table below.
Audio mes- Information
sages
RADIO The product is in FM radio mode.
HEADSET The product is in Headset mode.
FM radio mode
In FM radio mode you get access to FM radio.
579 - 005 - 05.07.2019
®
wireless technology.
To change FM radio station
• Push the rearward button or forward button to
change FM radio station. A beep sound tells you
when you are at minimum or maximum frequency.
To save a FM radio station in a pre-set slot
The FM Radio mode has 5 pre-set slots where you can
save FM radio stations.
1. To change pre-set slot, push and hold the forward
button or rearward button for 1 second. An audio
message tells you about the current pre-set slot.
Refer to the table below.
2. To save current FM radio station, push and hold the
On/Off/Mode button and forward button for 2
seconds.
Note: If you save a FM radio station in a pre-set slot,
it overwrites the FM radio station that was saved
before in that pre-set slot.
3. An audio message tells you when the FM radio
station is saved. Refer to the table below.
4. To save a FM radio station in the next pre-set slot,
push the rearward button or forward button for 1
second. Do the steps above again.
Audio message Information
PRE-SET 1-5
Tells you about the current pre-set
slot.
SAVED
The FM radio station is saved in 1
of the 5 memory slots.
Headset mode
In Headset mode you can connect your product to a
®
Bluetooth wireless technology . The product
device with
has support for A2DP, HFP and HSP. In Headset mode
you can use different streaming functions and accept
phone calls or two-way radio calls.
To do a pairing operation
1. Push and hold the On/Off/Mode button and forward
button for 2 seconds to start the pairing function on
your product.
2. An audio message tells you about the status of the
product. Refer to the table below.
Audio message
PAIRING
3. Start the function for
on the device.
4. Select Husqvarna X-COM R in the list of units on
your device.
Information
The pairing operation is
started.
®
Bluetooth wireless technology
9