Specifications - Monitor Audio PLW215 II Guía De Configuración Inicial

Specifications

System Format
Low Frequency Response
Upper Frequency Limit
Driver Compliment
Linear Driver Excursion
Amplifier Power Output
Amplifier Classification
DSP
Digital Conversion
LED UI Control Panel
Room Correction EQ
Phase Control
Low Pass Filter
Auto Sensing Input Level
Requirements
Digital Volume Control
IR Remote Control
Audio Input Connection
Sealed cabinet with vibration cancelling driver configuration. 25mm M.D.F construction with internal
-3dB @ 23Hz / -10dB @ 18Hz (Free Field) default preset: Music
-3dB @ 19Hz / -10dB @ 16Hz (In Room) default preset: Music
Limited by low frequency protection filter (-3dB @ 12Hz)
2 x 15" C-CAM® sub-woofer driver featuring inverted surround and triple suspension for
Black single layer, edge wound 3" voice coil with vented pole, vented coil and black CED coated motor
unit to reduce power compression and increase thermal dissipation.
FEA optimised cone, magnetics and suspensions for optimal performance and increased linearity.
42mm Peak to Peak. Total displacement 6.4 Litres
Dual amplifier design with a single amplifier powering each driver.
Combined 1400W RMS, 2000W Peak (Burst ratio 1:4 continuous, measured into two nonreactive 4 ohm loads)
2 x Class-D amplifiers; Balanced differential Input; Differentially loaded power supply; DSP controlled.
High current switch mode power supply (SMPSU)
172MHz DSP Core with 3500 instructions per sample, 139dB of dynamic range and 56-bit double precision
processing, dynamically updated by an 80MHz MCU
Wolfson Microelectronics (Cirrus Logic) ADC & DAC @ 24bit/48KHz.
Adjustable brightness 0% - 100%, configurable auto off feature.
Quick access to menu items: Trim, LPF, Phase, Preset Select.
6 System controlled parametric EQ filters set using advanced detection algorithm. Measurement can be
initiated from the control panel or the SubConnect with up to 6 microphone positions (default 2).
0-360 degrees, Increments of 15 degrees with a pure invert at 180 degrees
2nd or 4th order (12 or 24 dB/Octave), Increments of 5Hz from 35Hz to 135Hz
Line Level >1mV on unbalanced and balanced inputs.
Auto Standby feature, adjustable between 5-240 minutes in increments of 5mins
-11 to +11dB in 1dB increments, Via the control panel.
-80 to +20 in 1dB increments, via SubConnect application
Supplied with IR remote. Front facing IR receiver with red LED response.
Additional discrete IR codes for automation available in the electronic manual.
All commands are on the Logitech database for use with their all in on remotes.
LFE Input with balanced (XLR) and Unbalanced (RCA) inputs,
monitoraudio.com
Platinum PLW215 II
bracing and sealed amplifier compartment
-3dB @ 150Hz
increased support at high excursions.
(WM8786 ADC & WM8740 DAC)
Stereo Input with unbalanced (RCA) inputs.
Inputs individually assignable to any Preset.
cont....
7