Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Q
UICK CONFIGURATION GUIDE. DT-232
DVB-T Parameters (Output)
Carriers
Constellation
Channel bandwith
Guard Interval
Code Rate
Spectral Inversion
RF Output (DVB-T)
Type
Connector
Frequency Range
Power level (average)
Variable attenuation
from
Frequency Stability
MER
Phase noise SSB
Configuration
Transport Stream
Processing
Power supply
Connector
Voltage and highest
Consumption
02/2011
2k / 8k
QPSK, 16-QAM, 64-QAM
7 MHz, 8 MHz
1/4, 1/8, 1/16, 1/32
1/2, 2/3, 3/4, 5/6, 7/8
ON, OFF
2 DVB-T independent combined multiplexes.
BNC female connector, 50 Ω impedance.
From 474 to 875 MHz, in 1Hz step (see options
for output in VHF band).
Aprox. 85 dBµV without attenuation.
0 to 30 dB (in 1 dB step).
10 ppm
>36 dB from 650 MHz to 860 MHz
>38 dB from 474 MHz to 650 MHz
-87 dBc/Hz @ 2 kHz
Through the DT-800 Control Module in local
(keypad) or remote mode (PC). See DT-800
spec.
Selection of Services by Name or streams
filtering by PID (PID Filtering with Filtering Table
up to 32 PID)
Automatic Regeneration of PAT and SDT tables.
Adaptation of NIT table:
-
Editable NID (Network IDentifier).
-
Management
Number).
Measures on TS:
-
Bitrate of the output multiplex.
-
Percentage of bitrate used relative to the
maximum capacity of the multiplex
Via the DT-800 Control and Power module.
JST B08P-XL-HDS (Connecting Cable supplied
with the DT-800 module).
+12 V < 1.5 A ; + 5 V < 1.5 A.
for
LCN
(Logic
Channel
Page 3
Publicidad
Tabla de contenido
