Special Messages - Taurus RONER CLIP+ Manual De Instrucciones

- The icon and working lamp will flash in red
and it will enter in stand-by mode. You will hear
a sound of beep.
- Press the icon to enter the setting mode.
You will hear a sound of beep.
- Select the desired cooking temperature using
the scroll wheel.
- Select the cooking time pressing the icon ºC/º
and using the scroll whell. First, select the
hours and then the minutes pressing again the
icon.
- Press the icon to confirm the setting and
the unit will work. You will hear a sound of
beep. The working illuminator have to light in
blue.
- The temperature indicator will change as the
water warms up.
- The timer will countdown when it meets the
setting temperature.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- "END" will appear on the screen indicating that
the time has ended. You should hear 3 "beep"
sounds.
- Press and hold the
stop.
- Unplug the appliance from the mains.
- Clean the appliance.
SAFETY THERMAL PROTECTOR:
- The appliance has a safety device, which pro-
tects the appliance from overheating.
- When the appliance switches itself on and
off repeatedly, for reasons other than the
thermostat control, check to ensure that there
are no obstacles that impede correct air entry
or expulsion.
- If the appliance turns itself off and does not
switch itself on again, disconnect it from the
mains supply, and wait for approximately 15
minutes before reconnecting. If the machine
does not start again seek authorised technical
assistance.
icon for 3 seconds to

SPECIAL MESSAGES:

- When the EE1 message appears on the
screen, accompanied by 3 "beep", it may mean
that:
- The water level is below the minium level.
- The appliance was taken out of the water
while it was working.
- The water has evaporated.
- The appliance is being used without water.
CLEANING
- Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
- Disassemble the appliance, hold the unit and
rotate the skirt in anticlockwise (Fig. 2).
- Remove the turbine protector with a screwdriver.
- Clean the electrical equipment and the mains
connection with a damp cloth and dry. DO
NOT IMMERSE IN WATER OR ANY OTHER
LIQUID.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
- It is advisable to clean the appliance regularly
and remove any food remains.
- If the appliance is not in good condition of
cleanliness, its surface may degrade and
inexorably affect the duration of the appliance's
useful life and could become unsafe to use.
- The following pieces may be washed in a dish-
washer (using a soft cleaning program):
- Stainless Steel Skirt
- Water Pump Cap
- Then dry all parts before its assembly and
storage.