Infrared Remote Control (Irc) - Chauvet Gobo Shot 50W IRC Guía De Referencia Rápida

EN
Wired Remote
Infrared Remote
Control (IRC)
To operate the Gobo Shot™ 50W IRC with the included wired remote, plug
the wired remote into the Wired Remote In port on the back of the projector,
and use the remote as follows.
· To control the gobo's rotation speed, turn the ROTATION SPEED knob to
the desired speed (slow to fast).
· To control the direction of the gobo's rotation, flip the DIRECTION switch
to either CW (clockwise) or CCW (counter-clockwise).
· To control the power to the Gobo Shot™ 50W IRC, flip the MAINS
SWITCH switch to either OFF or ON.
Details can be
www.chauvetlighting.com.
The Wired Remote In/Out ports allow one Gobo Shot™ 50W IRC to
remotely control the actions of another Gobo Shot™ 50W IRC without the
need of an additional wired remote. Using a standard RJ45 (network)
cable, connect the projector with the wired remote from its Wired Remote
Out port to the Wired Remote In port of the other projector. Gobo Shot™
50W IRC projectors configured in this manner operate in unison.
The Gobo Shot™ 50W IRC is fully compatible with the Infrared Remote
Control (IRC) from CHAUVET®. For more information on the IRC or to
download instructions, go to www.chauvetlighting.com.
The following IRC buttons are used with the Gobo Shot™ 50W IRC:
· <BLACKOUT> - turns LED on/off
· <STROBE> - strobing (0–20 Hz)
· <SPEED> - gobo rotation
Note: After pressing the <SPEED> button, CU shows on the display until
you increase or decrease the gobo rotation speed (see below).
· <%> - master dimmer
· <MANUAL> - stops rotation
· <FADE/SNAP> - selects clockwise/counter-clockwise
· <+> (plus) - increases effect
- to increase gobo rotation, press the SPEED button first (settings 0–255)
- to increase strobing, press the STROBE button first (settings S000–S100)
- to increase dimming, press the % button first (settings L000–L255)
· <-> (minus) - decreases effect
- to decrease gobo rotation, press the SPEED button first (settings 0–255)
- to decrease strobing, press the STROBE button first (settings S000–S100)
- to decrease dimming, press the % button first (settings L000–L255)
· <0>–<9> - preset rotation speeds 0 to 9 (slow to fast)
The buttons on the IRC not listed above are reserved for future use with
the Gobo Shot™ 50W IRC.
Gobo Shot™ 50W IRC QRG
found in the
5
User Manual, available at