Maintenance; Safety Labels; Clogging Of The Mill / Cleaning Of The Mill - River MISTRAL Manual De Usuario

6. MAINTENANCE

riversystems.it
The maintenance operations must be carried out by specialized personnel, carefully following the instructions
given in the present manual.
WARNING!
BEFORE ANY MAINTENANCE OPERATION, MAKE SURE THAT THE MOTOR IS OFF AND
THE MACHINE IS UNPLUGGED.
riversystems.it
NOTE:
BEFORE ANY MAINTENANCE OPERATION OR CHECK, CLEAN THE WORKING AREA,
WEAR WORK GLOVES AND USE SUITABLE TOOLS THAT ARE IN GOOD CONDITIONS.
AFTER ANY MAINTENANCE OPERATION OR CHECK, RESTORE THE MACHINE GUARDS.
riversystems.it
After each use
Every 10 working hours
riversystems.it
Every 50 working hours
Every 200 working hours
riversystems.it
6A - SAFETY LABELS
As for the identification label of the machine, the safety labels must be kept visible and in a good state. If
necessary, replace them with new ones, to be required to the manufacturer.
riversystems.it
BEFORE STARTING THE GRINDING MILL WEAR A FACE SHIELD.
WAIT UNTIL ALL THE PARTS OF THE MACHINE ARE COMPLETELY MOTIONLESS
BEFORE TOUCHING THEM.
riversystems.it
READ THE USE AND MAINTENANCE MANUAL BEFORE STARTING THE MACHINE.
DISCONNECT THE TENSION BEFORE REMOVING THE GUARDS.
6B - CLOGGING OF THE MILL / CLEANING OF THE MILL
WARNING!
BEFORE CARRYING OUT THIS OPERATION, MAKE SURE THAT THE MOTOR IS OFF
AND THE MACHINE IS UNPLUGGED.
riversystems.it
riversystems.it
riversystems.it
riversystems.it
Copyright © 2019 River Systems - All rights reserved
riversystems.it
PERIODIC MAINTENANCE OPERATIONS TABLE
riversystems.it
riversystems.it
1. Unfasten the metal
belt and lift the upper
riversystems.it
part of the mill.
4. Reassemble the mill
with care.
riversystems.it
riversystems.it
We recommend a thorough cleaning of the inside of
Check the tightness of the screws.
Check the blade wear.
Make sure that the electric cord is in good condition
Check the rotating parts
Clean the motor and especially the cooling fan with
compressed air.
Make sure that the motor carbon brushes are in good
riversystems.it
2. Unscrew the wing
nuts that secure the
sieve and remove it.
3. Clean all the parts
with a cloth or with
riversystems.it
compressed air.
riversystems.it
- 17 -
riversystem
the mill
riversystems.it
condition
riversystem
riversystems.it
riversystems.
riversystems.it
EN
riversystems
riversystems
riversystems