Mark MK 1600 LED Manual De Uso página 6

EN
The fifth page
"T ilt Inverse"
This page allows to change the TILT axis sense by pressing the "UP" or "DOWN"
Manual control function
By the "TIMER", "VOLUME" and "STOP" button to manually operate the machine spraying
work. When the machine is heated well, the "Ready To Fog" is in the display page, press the
button "VOLUME", the machine w ill begin to work; press the bu tton "STOP", the machine will
stop work.
Note: Only the page displays "Ready To Fog", the button will work. Otherwise, bu ttons do not
work, and turn into conventional functions.
Wireless control function
ON Spray, OFF Stop
1. Identify the wireless transmitter
When the machine is powered and the remote control function se ttings page was set ON in
last use, the LCD controller will display "Wireless Set up", then the wireless transmitter can be
identified in this state. When you press the bu tton on the wireless transmitter (need to stay at least
1 second), if the LCD controller back light flashes twice, then explained that it had identified a
wireless transmitter. A machine can only identify 5 transmitter, if the five have been identified to a
wireless transmitter, and when identify the six, the initial identification should be cleared.
If the wireless controller has identified 5 wireless transmitter in last power, the identified
previously transmitters will be cleared, if at least one wireless transmitter is identified when
powered again.
For example:
A machine needs to identify 3 wireless transmitters. "Wireless Setup" displays on the LCD
screen within 15 seconds, please press any button of 3 wireless transmitters respectively. When the
LCD back light flashes twice, it identify a wireless transmitter, if the back light does not flash, you
will need to re-identify.
A wireless transmitter to control two or more machines. Two machines should be powered
simultaneously, when "Wireless Setup"displays on the LCD screen of the two machines, press any
MK 1600 LED - 5 -
User Manual/Manual de Uso