Description; Purpose; Overview; Safety - GreenWorks GD60BPB Manual Del Operario

EN
1

DESCRIPTION

1.1

PURPOSE

The machine is used to propel air out of a tube to move
unwanted materials such as leaves in the yard. Some
machines also suck in leaves and small twigs through a
vacuum, and shred them into a bag.
1.2

OVERVIEW

Figure 1 - 11.
Turbo button
1
Cruise control lever
2
Trigger
3
Front blower tube
4
Hose clamp
5
Rear blower tube
6
2

SAFETY

Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3

INSTALLATION

3.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine
before use.
• If the parts have damage, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the
service center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with
local regulations.
3.2

INSTALL THE TRIGGER HANDLE

Figure 2.
1. Move the trigger handle onto the rear blower tube.
Latch
7
Battery
8
compartment
Harness
9
10 Trigger handle
11 Flexible tube
WARNING
WARNING
WARNING
English
2. Move the trigger handle to necessary location on the
rear blower tube.
3. Install and tighten the available short screw.
3.3 INSTALL THE REAR BLOWER
TUBE
Figure 3.
1. Put the hose clamp around the flexible tube.
2. Put the end of the rear blower tube into the flexible
tube at a small angle.
3. Push the end of the rear blower tube into the flexible
tube.
4. Install and tighten the available long screw into the
hose clamp.
Put the cord in the cord retainer.
3.4 INSTALL THE FRONT BLOWER
TUBE
Figure 3.
1. Align the grooves on the front blower tube with the
tabs on the rear blower tube.
2. Install the front blower tube onto the rear blower
tube until the tabs engage the grooves.
3. Turn the front blower tube in the direction of the
arrow until the tabs lock into position.
3.5

INSTALL THE BATTERY PACK

Figure 4.
• If the battery pack or charger is damaged, replace
the battery pack or the charger.
• Stop the machine and wait until the motor stops
before you install or remove the battery pack.
• Read, know, and do the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the
grooves in the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.6

REMOVE THE BATTERY PACK

Figure 4.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4
WARNING
WARNING