ETI 54296141 Guía De Uso Y Cuidado página 5

Installation (continued)
5. Cut the wires shown as the diagram below. Optional: Remove ballast and starter and dispose or recycle in
accordance with local requirements.
Ballast
Inductive ballast type
Black
Ballast with 2 lamps
6. Make the new wire connection for new branch circuit wiring required and shown as in diagram below
Black
120-277~
White
The labeled end of LED Tube Lamp is the live, input powered end. The opposite end is electrically isolated and serves
as means of mechanical support only.
7. Reinstall the ballast cover over the wiring channel.
8. IMPORTANT: Install the xture warning label provided in a visible location after the LED Tube Lamp is installed,
possibly on the wiring channel cover.
Fixture Warning Labels
ETi SSL Inc. - The Americas Headquarters
26650 Renaissance PKW, STE 6
Cleveland, OH 44128
White Black
Starter
White
Ballast
Power this end
Non-shunted lamp holder required
Black
Electronic ballast type
Black
Ballast with 3 lamps
ETi SSL Integral LED Lamp
Please contact 1-855-384-7754 for further assistance.
5
White
Ballast
White
Ballast
www.etissl.com