Cleaning Tips; Maintenance; Changing The Internal Light; Care When Handling/Moving Your Unit - EAS ELECTRIC EMF161 Manual De Instrucciones

4. The grille of the condenser at the back of the unit and the adjacent
components can be vacuumed using a soft brush attachment.
3.4

Cleaning tips

●
Dusts behind the refrigerator and on the ground shall be timely cleaned to
improve the cooling effect and energy saving.
● Check the door gasket regularly to make sure there are no debris. Clean the
door gasket with a soft cloth dampened with soapy water or diluted detergent.
● The interior of the refrigerator should be cleaned regularly to avoid odor.
Please turn off the power before cleaning interior, remove all foods, drinks ,
●
shelves, drawers, etc.
● Use a soft cloth or sponge to clean the inside of the refrigerator, with two
tablespoons of baking soda and a quart of warm water. Then rinse with water
and wipe clean. After cleaning, open the door and let it dry naturally before
turning on the power.
●
For areas that are difficult to clean in the refrigerator (such as narrow
sandwiches, gaps or corners), it is recommended to wipe them regularly with
a soft rag, soft brush, etc. and when necessary, combined with some auxiliary
tools (such as thin sticks) to ensure no contaminants or bacterials
accumulation in these areas.
●
Do not use soap, detergent, scrub powder, spray cleaner, etc., as these may
cause odors in the interior of the refrigerator or contaminated food.
●
Clean the bottle frame, shelves and drawers with a soft cloth dampened with
soapy water or diluted detergent. Dry with a soft cloth or dry naturally.
●
Wipe the outer surface of the refrigerator with a soft cloth dampened with
soapy water, detergent, etc., and then wipe dry.
●
Do not use hard brushes, clean steel balls, wire brushes, abrasives(such as
toothpastes), organic solvents (such as alcohol, acetone, banana oil, etc.),
boiling water, acid or alkaline items, which may damage the fridge surface
and interior. Boiling water and organic solvents such as benzene may deform
or damage plastic parts.
●
Do not rinse directly with water or other liquids during cleaning to avoid short
circuits or affect electrical insulation after immersion.

4. MAINTENANCE

4.1

Changing the internal light

Lamp replacement by professionals.
4.2

Care when handling/moving your unit

Hold the unit around its sides or base when moving it. Under any circumstances
should it be lifted by holding the edges of the top surface
4.3

Servicing

The unit should be serviced by an authorized engineer and only genuine spare
parts should be used. Under any circumstances should you attempt to repair
the unit yourself. Repairs carried out by unqualified persons may cause injury or
serious malfunction. Contact a qualitatively technician.
4.4

Switching of long periods of time

When the unit is not in use for a long period of time, disconnect it from the
mains supply, empty all food and clean the appliance, leaving the door open to
prevent unpleasant smells.
.
V.1
26