Cut The Pump Banding Straps - Models With Support Blocks; Install The Plumbing - Kohler K-1122 Guia De Instalacion

4. Cut the Pump Banding Straps — Models With Support Blocks
IMPORTANT! This step is necessary to make your Kohler whirlpool operate more quietly.
Use tin snips to cut the two pump banding straps.
To minimize whirlpool noise and vibration, be sure the pump is not in direct contact with the
shipping bracket after the pump banding straps are cut.
Remove and discard the straps.

5. Install the Plumbing

CAUTION: Risk of property damage. Ensure a watertight seal on the whirlpool drain.
Connect the drain to the trap according to the drain manufacturer's instructions.
NOTICE: An access panel will simplify future maintenance.
Install the faucet valving according to the faucet manufacturer's instructions. Do not install the
faucet trim until instructed. Open the hot and cold water supplies, and check the supply
connections for leakage.
Run water into the whirlpool, and check the drain connections for leakage.
1010997-2-E
Suction Line
Drainage
NOTE: Pump model illustrated may differ from your
actual product.
Pump
Cut the pump
banding straps.
6 Kohler Co.