Cut The Pump Banding Straps - Kohler STERLING 66050100 Guia De Instalacion

9. Cut the Pump Banding Straps

For Standard Pump Only
IMPORTANT! This step is necessary to make your whirlpool operate more quietly.
IMPORTANT! Do not raise the pump higher than it was before you cut the pump banding straps. If the
pump is raised too high, it will not prime properly.
Cut the two pump banding straps from the whirlpool pump with a pair of tin snips. Discard the
banding straps.
Make sure that the pump is not in direct contact with the whirlpool harness.
10. Install the Drain and Test the Piping
CAUTION: Risk of property damage. Make sure that the whirlpool drain has a watertight seal, or the
whirlpool may leak.
Connect the drain to the trap according to the manufacturer's instructions.
Temporarily install the faucet handles and spout according to the manufacturer's instructions.
Turn on the hot and cold water supplies.
Check the supply connections for leakage. Repair any leaks.
Run the water to flush any debris from the lines.
Check the drain connections for leakage. Repair any leaks.
Close the faucet valves.
Install the showerhead, if applicable.
Test the showerhead for proper operation.
Turn off the hot and cold water supplies.
Remove the showerhead and reinstall the pipe cap.
Remove the faucet trim and spout according to the manufacturer's instructions.
1016904-2-C
Pump
Cut the pump
banding straps.
Pump Support
Bracket
16 Sterling