Final Steps - HUSABERG 69029096040 Manual Del Usuario

3
1
It is recommended that you only use the UST in cooperation with an authorized HUSABERG workshop.
You should be aware that use of the UST enables you to alter the adjustment of your motorcycle in such a way that the motorcycle
may cease to function properly and/or engine damage may occur. Use of the UST requires a special mapping on your motorcycle that
can be obtained from your HUSABERG dealer. When this mapping is transferred to your motorcycle, all warranty claims become null
and void. Because the UST is made up of electronic components, it must be handled with utmost care.Contact with dust, dirt and
water should be avoided.
1
4
5
Scope of delivery:
1x user setting tool (UST) adapter (1)
1x USB cable (2)
2
1x UST adapter protective sleeve (3)
1x diagnosis plug-in cable
Preparations
- Switch off the ignition.
- Jack up the motorcycle.
- Remove the seat.
Mounting the UST for riding
- Connect the diagnosis plug-in cable (4) with the motorcycle cable harness
and the UST adapter (1).
NOTE:
The plug-in connector (5) is used to activate and deactivate the ignition.
Plug-in connector disconnected --> ignition off.
Plug-in connector connected --> ignition on.
- Mount the adapter protective sleeve (3).
Pull the protective sleeve over the UST adapter, open the bracket of the air
filter fixation and push the loop of the protective sleeve on the bracket (figure
A).
Position the UST adapter with the protective sleeve in the correct position
and close the bracket again (figure B).
- Route the diagnosis plug-in cable.
3
A
Route the diagnosis plug-in cable such that it is not damaged when the seat
is mounted.
NOTE:
While data is being recorded during the ride, the plug-in connector (5) for
the ignition must be disconnected --> ignition off.

Final steps

- Mount the seat.
B
69029096000
69029096020
69029096030
69029096010
5