Axxess GMOS-04 Instrucciones De Instalación página 7

TROUBLESHOOTING:
Chime Too Loud/Soft:
There are some instances where the chime is too loud or too soft.
To resolve this follow these steps:
1. Make sure the ignition is turned to the "off" position.
2. Disconnect the 14 pin and 16 pin wire harnesses from the GMOS-04.
3. Locate the potentiometer on the left side of the module, this is the Chime potentiometer.
4. Taking a small flat headed screwdriver, turn the potentiometer clockwise to decrease the chime level; turning
the potentiometer counterclockwise will increase the chime level.
POTENTIOMETER
CHIME LEVEL
ADJUSTMENT
Distorted Audio Output:
When using the GMOS-04 with a radio that has a high pre-out voltage, usually greater than 2 volts, the audio
signal may become distorted.
To resolve this follow these steps:
1. Make sure the ignition is turned to the "off" position.
2. Disconnect the 14 pin and 16 pin wire harnesses from the GMOS-04.
3. Locate the potentiometer next to the 14 pin connector located at the end of the GMOS-04.
4. Taking a small flat headed screwdriver, turn the potentiometer counter clockwise to lower the input level
going to the factory amplifier.
GMOS-04
6
POTENTIOMETER
AUDIO LEVEL
ADJUSTMENT