Indicator Light - LC-POWER LC-M44-DFHD-120 Manual Del Usuario

7. Basic Opera�on
1. Insert one end of the DP cable into your PC's graphics card. An HDMl cable
may also be used. HDMI cable is not included.
2. Connect the other end of the cable to the corresponding connector on
your monitor.
Type-C
HDMI Connectors Audio Output
3. Connect the power cable to your monitor then connect the other end to
your power source. It is recommended that you use a surge protector with
adequate voltage if a wall outlet cannot be reached directly.
4. Locate the power bu�on on the monitor and press it to turn the monitor on.
FreeSync
The feature itself is off by default. In order to use this feature, please note you
must have hardware with FreeSync capability, an DP cable, and the latest graphic
drivers. To use this feature, connect your computer and monitor with an DP
cable. A�er connec�ng, you may receive a prompt to enable the feature on
your computer. If you do not receive the prompt, you may need to enable the
func�on in your graphics card menu. See your graphics card manufacturer's
documenta�on for instruc�ons on how to turn on or enable FreeSync.
8. Light lndicator
Solid blue light indicates power is on and the monitor is opera�ng normally.
Flashing blue light indicates no video source, no horizontal or ver�cal signal
has been detected or power is low.Please ensure your computer is on and all
video cables are fully inserted and/or connected.
DP Connectors
Eng-6
USB IN
USB OUT Power Connector

Indicator light