Error Function; Delay Times (0 To 9.99 S) - Parker SCPSDi Manual Del Usuario

6.3

Error function

Errors will be displayed as they occur (Err1, Err2, Err4, Err8) (Refer to
menu point Err).
6.4

Delay times (0 to 9.99 s)

Setting delay times make it possible to filter out unwanted short-term or
high-frequency measurement peaks (attenuation).
In order for the switch to actuate, the measured value must exist for this
amount of time. The state of the switching output is not altered immedi-
ately when the switching event is reached, but only after the delay time
has elapsed. If the switching event is no longer in existence after the
delay time has elapsed, the switching output does not change. (Refer to
menu options dS and dr.)
45