Recommended Hookup - Freeman PF20LM Manual Del Usuario

MODEL: PF20LM
CLEANING
Avoid using solvents when cleaning plastic
parts. Most plastics are susceptible to damage
from various types of commercial solvents and
maybe damaged by their use. Use clean cloths
to remove dirt, dust , oil, grease, etc.
Do not at any time let brake fluids,
gasoline, petroleum-based products,
penetration oils,ect. come in contact with
plastic parts. Chemicals can damage,
weaken,or destroy plastic which may
result in serious personal injury.
COLD WEATHER OPERATION
For cold weather operation, near and below
freezing, the moisture in the air line may freeze
and prevent tool operation. We recommend the
use of air tool lubricant or permanent antifreeze
(ethylene glycol) as a cold weather lubricant.
CAUTION:
Do not store tools in a cold weather
environment to prevent frost or ice
formation on the tool s operating valves '
and mechanisms that could cause tool
failure.
Quick
Coupler
Air hose
Quick
connector
12
HTTP://WWW.FREEMANTOOLS.COM

RECOMMENDED HOOKUP

1. The air compressor must be able to
maintain a minimum of 70 psi when the tool
is being used. An inadequate air supply can
cause a loss of power and inconsistent
driving.
2. An oiler can be used to provide oil
circulation through the tool. A filter can be
used to remove liquid and solid impurities
which can rust or gum up internal parts of
the tool.
3. Always use air supply hoses with a
minimum working pressure rating equal to
or greater than the pressure from the power
source if a regulator fails,or 150
psi,whichever is greater. Use 3/8'' air hose
for runs up to 50' and use 3/8'' quick coupler
on the air hose.
4.
Use a pressure regulator on the
compressor, with an operating pressure of
0-125 psi. A pressure regulator is required to
control the operating pressure of the tool
between 70 and 115 psi.
CAUTION:
The air compressor must be able to
maintain a minimum of 70 psi when the
tool is being used. An inadequate air
supply can cause a loss of power and
inconsistent driving.
Do not connect with an air compressor
which can potentially exceed 200 psi. As
tool may burst, possibly causing injury.
Quick
Filter
Oiler
connector
Compressor
Quick
Regulator
Coupler
1-888-669-5672
MODEL: PF20LM
TROUBLESHOOTING
! WARNING:
Stop using tool immediately if any of the following problems occur. Serious personal
injury could result. Any repairs or replacements must be done by a qualified service
person or an authorized service center.
HTTP://WWW.FREEMANTOOLS.COM
1. Use 20 gauge 1'' to 1-1/2'' L-cleats.
13
1-888-669-5672