Publicidad
Idiomas disponibles
Idiomas disponibles
1.2. QUICk StaRt
this part contains the useful information about the radio timing installation radio.
1.2.1. Fixings and installation
The product can be put on a wall at a minimum distance from the floor of 1 meter.
☛
Metallic room and wall must be avoid in order to keep the best
1.2.2. Functioning wItH tDF/DCF antEnna
►
the transmitter must be plug on a 230vaC power supply source. tdF or dCF an-
tenna must be plugged and correctly installed. For a cold start (first start) the red led
on the front face is Flashing in time with radio code.
►
if a correct tdF or dCF code is received the red led is Flashing at one-second
intervals. it means radio transmission is occurring.
►
In the event of first installation you have the possibility of forcing the transmitter in
permanent emission by activating the switch number 8 in on position. the red Led
in the front face will stay lighted in this mode.
ATTENTION this mode is reserved only for the installation to test all
the receiving clocks. This mode must be removed by repositioning
the switch 8 on OFF once the installation is finished. The LED in
front flashes again in normal mode.
►
if the installation mode is activated before the issuer has been synchronized least
once, time will be transmitted to the time base of the issuer will operate autono-
mously and have started at 0H00.00s.
18
☛
Some rules must be respected.
performances of the system.
MDE-RTnetwork-3076V1.3
Publicidad
Capítulos
