Mains Voltage; Overheating Protection - Starmix TF12 Instrucciones Para El Montaje Y El Uso

GB
1. Safety instructions

Mains voltage

Connect only to threephase current 230–240 V. This
appliance conforms with EU directives 89/336/EEC and
73/23/EEC.
Caution! Never use the hairdryer in the vicinity
of baths, wash basins or other vessels contain-
ing water. Do not submerge the appliance in
water, proceed with wet cleaning or use with wet hands.
Never use hair spray while the appliance is switched on.
The risk also persists when the hairdryer is switched off,
therefore always disconnect from the mains after use, or
switch off the wall bracket switch. Never cover the air
suction opening and blow-out mesh. A residual current
operated device with a nominal triggering current of
no more than 30 mA can be fitted in your house
installation for additional protection. Please contact your
electrician. Never let children use the appliance without
supervision.

Overheating protection

The appliance switches off automatically in the case of
thermal overload. When this happens, switch the switch
to 0 or release the push button and eliminate the
external causes of overheating. Once the appliance has
cooled down it will be ready to use again in a few
minutes. Defect hairdryers may only be repaired by
qualified experts.
Care
As a general rule, the rnains plug rnust be disconnected,
or in the case of hairdryers with wall bracket, the switch
on the wall bracket must be switched to "OFF": Wipe the
appliance with a damp cloth and clean the mesh with a
fine brush or vacuum cleaner.
2. Instructions for the wall brackets
To be fitted by a qualified expert taking due consideration of
existing national safety regulations. In rooms containing
showers or baths, the wall bracket may not be fitted within
the safety zone stipulated in regulation 0100 part 701. The
wall bracket should be fitted at a height of at least 150 cm
above the floor.
4
3. Installation sequence;
for fixed connection lead (A)
1. Break the cable leadthrough 1 in the rear wall of the
wall bracket.
2. Pull the cable wires 2 coming out of the wall through the
open leadthrough 1.
3. Fix the rear wall to the wall using normal plugs and
wood screws.
4. Fix the cable wires 2 in the terminal 3 as illustrated. To
do so, remove the terminal 3 and then put it back again.
5. After testing the haidryer, place the wall bracket housing
in this position and fasten with the housing screw 4.
4. Installation sequence;
for mobile connection lead (B)
1. Break the membrane 5 in the lower edge of the rear wall
to take the second anti-kink bush 6.
2. Fasten the rear wall to the wall with normal plugs and
wood screws.
3. Pull the anti-kink bush 6 over the mobile connection
lead 7.
4. Mount the connection lead 7 to the terminal 3 as
illustrated. To do so, remove the terminal 3 and then put
it back again.
5. Place the anti-kink bush 6 in the provided seat and
mount the lead 7 as illustrated with strain relief 8 using
two screws.
6. After testing the hairdryer, place the wall bracket
housing in its position and fasten with the housing
screw 4.