Descargar Imprimir esta página

Palram Feria 3x5.4 Instrucciones De Montaje página 2

Ocultar thumbs Ver también para Feria 3x5.4:

Publicidad

EN
Please read these instructions carefully before you start to
assemble this product.
Please carry out the steps in the order set out in these instructions.
Keep these instructions in a safe place for future reference.
When encountering the information icon, please refer to the relevant
assembly step for additional comments and assistance.
Care and Safety Advice
Please follow the instructions as listed in this manual.
Sort the parts and check the list of contents.
For safety purposes we strongly recommend the product to be assembled
by at least two people.
Some parts may have sharp edges. Please be careful when handling components.
Always wear gloves, eye protection, and long sleeves when assembling or
performing any maintenance on your product.
Do not attempt to assemble the product in windy or wet conditions.
Dispose of all plastic bags safely – keep them out of reach of small children.
Keep children away from the assembly area.
Do not attempt to assemble the product if you are tired, have taken drugs,
medications or alcohol, or if you are prone to dizzy spells.
When using a stepladder or power tools, make sure you follow the
manufacturer's safety advice.
Do not climb or stand on the roof.
Heavy articles should not be leaned against the poles.
Do not hang or lay on the profiles.
Keep roof and gutter clear of snow, dirt & leaves.
Heavy snow load on roof can damage the product making it unsafe to stand
below or nearby.
This product was designed and produced to be used as a Patio cover only.
Some versions of this product are painted.
If color was scratched during assembly it can be fixed with the following tints:
White – RAL 9016 Grey – RAL 7012
Cleaning Instructions
When your product needs cleaning, use a mild detergent solution and rinse
with cold clean water.
Do not use acetone, abrasive cleaners, or others special detergents to clean
the panels.
Before Assembly
This product must be assembled on a solid base (such as concrete or asphalt)
and anchored to the ground.
Choose your site carefully before beginning assembly.
Sort the parts and check according to the contents parts list.
Site surface needs to be leveled (mainly below the poles).
Please consult your local authorities if any permits are required prior to
constructing the product.
Prior to enlarging the Patio Cover, several parts need to be dismantled, it is
recommended to keep them in a safe place for future use.
Note: Use only the parts registered in the content list, some parts may be
surplus.
Tools & Equipment
T001 (Supplied)
5mm
10mm
3/16"
25/64"
SILICONE \
13mm
CAULK

Publicidad

loading