Using The Fm Radio - HoMedics PDM-200B Manual De Usario

USING THE FM RADIO

Earbud Jack
Radio Scan Button
Radio Reset Button
To use the FM Radio, simply insert the
earbud connector into the jack located
on the device. The radio station will
automatically be displayed on the screen
indicating that the radio is ON.
To control the volume, use the dial located
on the earbuds to make the sound louder
or softer.
Press the RADIO SCAN button located
on the front of the device to increase FM
frequency to the next FM station with
reception. Continue to press the RADIO
23
SCAN button to get the desired station.
To reset the stations back to the lowest
FM frequency, press the RADIO RESET
button located on the front of the device.
Note:
• By removing the earbuds connector
from the jack on the pedometer, the
radio will automatically turn OFF.
• If at any time, you insert the earbuds and
you don't hear any sound, follow the
below steps:
> Make sure the volume is loud enough
for you to hear.
> Press the RADIO SCAN button to
check if you hear the radio changing
from station to station, or if the station
is displayed on the LCD screen.
• If after doing both of the above steps,
you still don't hear any sound, you
may need to change the batteries for
the radio. As noted in the INSTALLING
THE BATTERIES section, the batteries
for the FM Radio are located on the left
side of the battery compartment. See
INSTALLING THE BATTERIES section for
more details.
24