FIC K8M-800T/M Manual página 33

First/Second/Third Boot Device
This feature allows you to select the boot device priority.
The o ptions are: Flop py, LS120, Hard Disk, CDROM, ZIP100, USB-FDD,
USB-ZIP, USB-CDROM, LAN, Disabled.
Boot Other Device
This feature allows you to select the boot device priority.
The options are: Enabled, Disabled.
Swap Floppy Drive
Allows you to swit ch the order in which the operatin g system accesses
the floppy drives during boot up. The options are: Enabled, Disabled.
Boot Up Floppy Seek
When enabled, assigns the BIOS to perform floppy diskette drive tests by
issuing the time-consuming seek commands.
The options are: Enabled, Disabled.
Boot Up Numlock Status
When set to On, allows the BIOS to aut omatically enable the Num Lock
Function when the system boots up. The options are: On, Off.
Typematic Rate Setting
The term t ypemat ic means that when a key board key is held down, the
character is repeatedly entered until the key is released.
The options are: Disabled, Enabled.
Typematic Rate (Chars/Sec)
This feature is available only if the above item, Typematic Rate Setting, is
set at Enabled. Sets th e rat e of a character repeat wh en th e key is h eld
down. The options are: 6, 8, 10, 12, 15, 20, 24, 30.
Typematic Delay (Msec)
This feature is available only if the item, Typematic Rate Setting, is set at
Enabled. Sets the delay time before a character is repeated.
The options are: 250, 500, 750, 1000 millisecond.
BIOS Setup
3 - 5