Asus BX700 Manual Del Usuario página 58

There requires a one-time connection between the mouse and the available
Bluetooth-enabled PC or Laptop.
Please follow the steps below to finish the connection:
1. Before you can install your BX700 Bluetooth mouse, please make sure you have
done the Bluetooth dongle installation procedure.
2. Press and release the "CONNECT" button on the bottom of the BX700. The red
light led under the wheel button will be turn on.
3. On your computer system, double click the
advanced configuration program.
4. Follow the indication of the advanced configuration program to setup the HID
Bluetooth mouse driver.
Note: If you press the "connect" button by mistake, you should re-pairing,
follow the steps 1 to 4 again.
BATTERY LOW INDICATOR
When battery voltage level goes under the preset level, the LED on the mouse top cover
will blink frequency. Although the mouse can still work for a while, the user, at this time,
should have a new set of batteries ready for replacement as soon as possible.
POWER ON/OFF MOUSE
Power off the mouse
For traveling user, this BX700 provides one sliding-switch on the bottom of mouse. User
just pushes the sliding-switch to the "OFF" position to power-off this BX700.
Power on the mouse
When this BX700 is in sleep mode, to activate the mouse again, just need to move the
mouse. If this mouse is power-off, user needs to push the sliding-switch to the "ON"
position, and move this BX700 to wake up the mouse connection.
Link
Bluetooth icon, and select the