Arachnid BULLSHOOTER ILLUMINATOR 3.0 Instrucciones Y Reglas página 7

BUTTONS FUNCTION
POWER button - Press to turn game on or off. Dartboard has an automatic suspend mode to
conserve power and battery life (if using batteries). The dartboard will make sound effect and
display "SLEEP" on the display after approximately 5 minutes of non-use. However, the scores
are stored in memory and can be restored by pressing any button.
SOUND button - Press to change volume to high, low, or off.
PLAYER button - This button is used at the start of each game to select the number of players
you want to play the game. In addition, press and hold this button allows players to see other
player scores of not on active display. This dartboard keeps track of up to 4 player scoring or 4
two-person teams. When playing with more than 2 players, some scores will be not be visible
when not active. This button allows you to page through all players
DOUBLE / MISS button - This button is used to activate the Double In / Double Out option for
games which has Special Functions and only active on these games. Also press this button if
you wish to register a dart that misses the target area.
s o S OLO PLAY b
button-This button is used at the start solo play mode.In this mode,player will
against computer.
START / HOLD button - This multi-function button is used to:
START the game when all options have been selected.
CHANGE to the next player when one player is finished with his round. This will put
dartboard in HOLD status between rounds to allow player to remove darts from the target
area.
GAME buttons - Press to page through the on-screen game menu.
HECKLER button - This button is used to activate Interactive Heckler® Game Play Feature.
DISPLAY PROTECTIVE FILM
This electronic dartboard may have a clear film over the entire display area to prevent
scratching during shipping. It is recommended that this film be removed before play to enhance
the display area visibility. To remove, simply lift edge, peel off, and discard.
ELECTRONIC DARTBOARD OPERATION
1. Press the POWER button to activate dartboard. A short musical introduction is played as the
display goes through power-up test. Press GAME buttons until desired game is displayed.
2. Press PLAYER button to select the number of players (1, 2, 3, 4, t 2-2, t 3-3, t 4-4). The
default setting is 2 players.
3. Press START button to activate game and begin play.
4. Throw darts
The dart indicator display is located to the right of the score display. The number of darts
displayed indicate the remaining throws for the active player.
All Rights Reserved
©2014 Escalade Sports
DARTBOARD FUNCTIONS
7
ILM300
scores as needed.
For Customer Service Call 1 -800- 526 - 0451