Operation; Technical Service - Campbell Hausfeld AT122700 Manual De Instrucciones Y Lista De Piezas

2 . Attach the air compressor hose
to the air inlet (1/4 inch NPT(F))
at the bottom of the gun handle .
An optional quick coupler and
connector can be used to attach the
hose to the gun .
noTE: Do not cover the hole in the
hose connector for dry blasting . For
spraying liquids, slip the material hose
fully on to the hose connector covering
the hole .

operation

1 . Locate the compressor as far away
as possible from the sandblasting
area to minimize the dust in the
compressor intake .
2 . The air supply must be clean and
free of moisture and oil .
notes
3 . Use a compressor that can supply
enough air (See Specifications) . A
compressor too small will cause air
pressure to drop and the sandblaster
will not operate satisfactorily .
4 . Always trial test the sandblaster to
make sure the job is done without
damage by testing on a hidden
surface .
5 . Always filter (screen) the abrasive
material to remove any caked
material and debris to prevent
clogging .
6 . Do not try to spray thick liquids or
large grain size abrasives .
7 . Use the lowest effective pressure on
soft surfaces to prevent pitting the
surface .
3
8 . Liquids, such as soap and water, can
be sprayed for cleaning purposes on
automobiles, lawn chairs, etc .
9 . Insert the pick-up tube into the
bucket or bag of abrasive material .
10 . With air hose and material hose
connected, and wearing proper
safety equipment, aim sandblast gun
at surface and pull trigger .
11 . Whenever the nozzle is removed
and cleaned or replaced, use a brush
to clean the threads and replace the
o-ring .

Technical Service

For information regarding the
operation or repair of this product,
please call 1-800-543-6400 .
www.chpower.com
aT122700