The Wheel Unit; The Pedals; Operating Modes; Digital Vibration-Mode - FANATEC SPEEDSTER 3 ForceShock Manual De Instrucciones

3.1.2 The Wheel Unit

The steering wheel is attached to the wheel unit. This also contains
the directional buttons (left) and the LED display.

3.1.3 The Pedals

The left pedal is the brake and the right pedal acts as the
accelerator. If the analog mode is supported by the game, the
pedals are pressure sensitive.

3.2 Operating Modes

The SPEEDSTER ® 3 ForceShock has 3 different operating
modes, which are indicated on the display. You can change modes
by using the "MODE" switch, providing they are not activated
automatically.
3.2.1 Digital
Vibration-mode
The digital mode was developed to ensure full compatibility with
older (PlayStation ® 2 and PlayStation
With racing games that support a vibration function, this function
will be in evidence in the appropriate situations, such as during a
collision with another vehicle or a wall.
3.2.2 Analog
Vibration-mode
The SPEEDSTER ® 3 ForceShock's analog mode enables the
precise amount of movement required. This mode emulates the
analog function of the Analog Controller (DUALSHOCK
Analog Controller (DUALSHOCK
can be felt with the corresponding software (see above).
3.2.3 ForceShock
mode
This mode is based on the analogue vibration mode (see above).
The Force feedback engine is active in addition to the vibration
effect of the two vibration engines. As a result, the condition of the
roadway is conveyed in a realistic manner through the movement
of the steering axle.
4
® ) games.
) and the
®
® 2). Here, too, the vibration effect