Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Trunk pan
Tow hook
Hitch Shown In Proper Position
Equipment Required: Sealant
F t
Fastener Kit: F24720
Kit F24720
Wrenches: 3/4, 7/8
Drill Bits: 7/16"
1
Qty. (2)
Carriage Bolt 7/16-14 X 1.75
2
Qty. (2)
Spacer 3/16 X 1.00 X 2.00
3
Qty. (2)
Flat Washer 7/16
4
Qty. (2)
Lock Washer 7/16
5
Qty. (2)
Nut 7/16-14
1.
Remove table/well cover, spare tire & plastic well from trunk.
2.
Attach hitch to tow hook as shown above.
3.
Using hitch as template, drill (2) 7/16" holes in trunk pan.
4.
Install 7/16" carriage bolts, blocks, washers and nuts as shown above.
5.
Seal holes drilled in trunk pan to prevent intrusion of exhaust fumes and water.
6.
Return table/well cover, spare tire & plastic well to proper position in trunk.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2002, 2003, 2004, 2006, 2010 Cequent Performance Products
Installation Instructions
Honda Element
Fascia
Drawbar Kit:
3592
3592
Drawbar must be used in the
Rise position only.
1
2
3
4
5
7
6
6
Tighten all 7/16 GR5 fasteners with torque wrench to 50 Lb. Ft. (68 N M)
Tighten all 7/16 GR5 fasteners with torque wrench to 50 Lb -Ft (68 N*M)
Tighten all 1/2" GR5 fasteners with torque wrench 75 Lb.-Ft. (102 N*M)
Do Not Exceed Lower of Towing Vehicle
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
2000 LB (908 Kg) Max Gross Trailer Weight
200 LB (90.8 Kg) Max Tongue Weight
Wiring Access Location: SUV3
Seal holes drilled in trunk pan
to prevent intrusion of
exhaust fumes and water.
h
7
Tow hook
8 9
6
Qty. (1)
Hex Bolt 1/2-13 X 2.50
7
Qty. (3)
Spacer 1/4 X 1.50 X 3.00
8
Qty. (1)
Lock Washer 1/2
9
Qty. (1)
Hex Nut 1/2-13
Sheet 1 of 3
N24720
Part Numbers:
24720
77034
60278
f
d
Drilled 7/16" holes
Trunk pan
8-27-10
Form F206 Rev A 5605
Rev. D
Publicidad
Manuales relacionados para Cequent 24720
Resumen de contenidos para Cequent 24720
- Página 1 Do not cut access or attachment holes with a torch. This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684. 2002, 2003, 2004, 2006, 2010 Cequent Performance Products Sheet 1 of 3 N24720 8-27-10 Rev.
- Página 2 Ce produit est conforme aux normes V-5 et SAE J684 de la V.E.S.C. (État de New York) concernant les spécifications en matière de sécurité des systèmes d’attelage. z 2002, 2003, 2004, 2006, 2010 Cequent Performance Products Feuille 2 de 3...
- Página 3 Este producto cumple con las especificaciones y requisitos de seguridad para conectar dispositivos y sistemas de remolque del estado de Nueva York, V.E.S.C. Regulación V-5 y SAE J684 2002, 2003, 2004, 2006, 2010 Cequent Performance Products Hoja 3 de 3...