Lenco L-85 Manual De Instrucciones página 7

1. Adaptor:
Use this adaptor when playing 45 RPM records.
2. Platter:
Place a record here to play.
3. 33/45 RPM Switch:
Switch 33 or 45 rpm for playing a record at a correct speed.
4. REC:
Press it to enter into record mode.
5. SPLIT
For stopping the current recording, forming a record file manually and then going on recording
the next track.
6. Pick-up arm stand
7. Pick-up Arm Lift Stick:
To raise up and down the Pick-up Arm and cue at a proper place of a vinyl.
8. Pick-up Arm Lock:
Use this to lock the Pick-up Arm in place when not in use.
9. Dust Cover:
Use this to protect the turntable from exposure to dust. The cover may be opened or removed
during use, but should remain closed when the turntable is not in use.
10. RCA Line Out Cable
Connect the RCA line out to a mixer or an amplifier in your sound system.
11. Power Switch:
For turning the power on or off through this switch. Please switch off the unit after finishing the
playing to save the energy..
12. Power Adaptor Connection
Connect here the AC adapter output.
13. USB Port Input:
Plug in a USB Pen Drive for recording the music from a record.
*The design is only for USB Flash Drive. To prevent the power supply is not sufficient and
overheated of the circuit(IC), always get the external power supply if using a hard drive.
14. Reject
Press it to force the arm to return directly to the arm rest
15. LED
• USB Record Operation and LED Signal Indication
• USB storage device is not plugged. -> LED light is off
16. USB storage device is plugged in -> LED flashes
17. When the system is ready to record. -> LED light is on
18. Press REC button to start recording. -> LED blinks slowly.
19. Press SPLIT button to create new file in the recording.
20. Press REC button again to stop recording. -> LED is flashing for a short time, then LED light is stably on
again.
Note: Do not remove the USB storage device if the LED is flashing.
7