SWAGTRON T3 Manual Del Usuario página 19

When the rider steps on a pedal, the SWAGTRON® will adjust itself to balance automatically.
If the SWAGTRON® does not enter self-balancing mode
when triggering the foot-switch, the warning LED will
light up. DO NOT operate the SWAGTRON® under these
conditions. Please power the unit off and back on again. If
this fails to work, please re-calibrate the SWAGTRON® by
following the calibration instructions on section 3.3.
If you are on a slope, move the SWAGTRON® to
D DW DUHD ,I \RX DUH VWLOO UHFHLYLQJ WKH ZDUQLQJ
light, contact SWAGTRON® technical support
immediately.
NOTE:
When riding the SWAGTRON®, you must make sure both feet
are touching the pedals for proper detection. Do not put
other objects on the pedals, as it could cause the system to
lock or self-drive.
NOTE:
+ Do not tilt forward or backwards beyond 10 degrees, as the unit may malfunction.
+ 7KH 6:$*7521Š ZLOO QRW IXQFWLRQ LI \RXU XQLW LSV XSVLGH GRZQ
+ Avoid uneven or rocky surfaces as the SWAGTRON® may not function properly.
Swagtron T3 Hands Free Smart Board
Swagtron UM-T3-Tri-Lingual-0624.indd 19
19 English
6/28/2016 4:42:25 PM