Publicidad
Idiomas disponibles
Idiomas disponibles
Exhaust System Installation:
Warning: Use extreme caution during installation. Torque all fasteners according to the manufacturer's torque values and
tightening sequence. DO NOT use air impact tools to tighten fasteners on the Chevrolet Performance 1.4L Turbo Stage Kit
exhaust system. Use of such tools may result in bent flanges or gasket contact areas leading to exhaust leaks.
1. Using the hardware from the original exhaust system and new gasket from the kit, place the front resonator pipe up into position as
shown in Picture #5. Hand tighten the hardware for now.
Picture #5
2. Place a clamp over the expanded end of the intermediate pipe and set it into position as shown in Picture #6, installing the hangers
into the rubber isolators. Do Not tighten the clamp.
Picture #6
3. Place a clamp over the expanded end of the rear muffler assembly and set it into position as shown in Picture #7, installing the hangers
into the rubber isolators. Do Not tighten the clamp.
Picture #7
Sonic 1.4 L Turbo Stage Kit
TITLE
ALL INFORMATION WITHIN ABOVE BORDER TO BE PRINTED EXACTLY AS SHOWN ON 8 1/2 x 11
WHITE 16 POUND BOND PAPER. PRINT ON BOTH SIDES, EXCLUDING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE WITH GM SPECIFICATIONS.
23444740
REV 24JA17
PART NO.
DATE
Previous Revisions are Archived
19MY16
Revision - Vinod Kaushal
Revision - Vinod Kaushal
01JL16
24JA17
Revision - Vinod Kaushal
4
SHEET
REVISION
21
OF
AUTH
JHFGT
JNNJW
JXZDR
Publicidad
