INSTALL EXHAUST DIFFUSERS
6" ROUND
INSULATED
FLEXIBLE DUCT
TO
VENTILATOR
CEILING
DRYWALL
DIFFUSER
Follow instructions packed with diffuser(s). General
instructions:
1. Cut hole(s) in ceiling drywall and install diffuser(s).
2. Connect insulated ductwork to diffuser(s) and use
duct tape or clamp (available separately) to seal
connection(s).
3. Rotate center of diffuser(s) counterclockwise to fully
open for maximum air flow. Reduce air flow by rotating
center of diffuser(s) clockwise to desired opening. A
balancing damper (available separately) can be used
to adjust airflow.
PART
KEY
NO.
NO.
1
99150591
Screw, #10 x 7/8" (4 required)*
2
97011393
Housing Assembly (includes Key No. 7)
3
98005512
Wiring Adapter Plate
4
99150471
Ground Screw, #10-32 x 1/2"
5
97008575
Wiring Harness
6
99260477
Whiz Nut, 1/4-20 (2 required)*
7
99420470
Grille Nut (2 required)
8
98005513
Outlet Box Cover
9
99400035
Strain Relief Bushing
10
97011394
Blower Wheel (SP100)
97011395
Blower Wheel (SP140)
97011396
Blower Wheel (SP200)
11
97011361
Blower Housing (SP100)
97011362
Blower Housing (SP140)
97011363
Blower Housing (SP200)
12
99100412
Motor Mounting Rubber
13
97011400
Motor (SP100) (includes Key No. 16)
97011401
Motor (SP140) (includes Key No. 16)
97011402
Motor (SP200) (includes Key No. 16)
14
95000963
Motor Cup
15
99170245
Screw, #8B x 3/8" (10 required)*
16
97011403
Capacitor (SP100)
97011404
Capacitor (SP140)
97011405
Capacitor (SP200)
17
97011406
Cover
**
97011407
Blower Assembly Complete (SP100)
(includes Key No.s 10 thru 16)
**
97011408
Blower Assembly Complete (SP140)
(includes Key No.s 10 thru 16)
**
97011409
Blower Assembly Complete (SP200)
(includes Key No.s 10 thru 16)
* Standard Hardware - May be purchased locally.
** Not shown assembled.
Always order replacement parts by "Part No, - not by "Key No."
Broan-NuTone warrants to the original consumer purchaser of its products that such products will be free from defects in materials or workmanship for a period of one year from the date of original purchase. THERE ARE NO
OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
During this one-year period, Broan-NuTone will, at its option, repair or replace, without charge, any product or part which is found to be defective under normal use and service.
THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS, TUBES, HALOGEN AND INCANDESCENT BULBS, FUSES, FILTERS, DUCTS, ROOF CAPS, WALL CAPS AND OTHER ACCESSORIES FOR DUCTING.
This warranty does not cover (a) normal maintenance and service or (b) any products or parts which have been subject to misuse, negligence, accident, improper maintenance or repair (other than by Broan-NuTone), faulty
installation or installation contrary to recommended installation instructions.
The duration of any implied warranty is limited to the one-year period as specified for the express warranty. Some states do not allow limitation on how long an implied warranty lasts, so the above limitation may not apply to you.
BROAN-NUTONE'S OBLIGATION TO REPAIR OR REPLACE, AT BROAN-NUTONE'S OPTION, SHALL BE THE PURCHASER'S SOLE AND EXCLUSIVE REMEDY UNDER THIS WARRANTY. BROAN-NUTONE SHALL NOT BE LIABLE
FOR INCIDENTAL, CONSEQUENTIAL OR SPECIAL DAMAGES ARISING OUT OF OR IN CONNECTION WITH PRODUCT USE OR PERFORMANCE. Some states do not allow the exclusion or limitation of incidental or consequential
damages, so the above limitation or exclusion may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state. This warranty supersedes all prior warranties.
To qualify for warranty service, you must (a) notify Broan-NuTone at the address or telephone number below, (b) give the model number and part identification and (c) describe the nature of any defect in the product or part. At
the time of requesting warranty service, you must present evidence of the original purchase date.
Broan-NuTone LLC, 926 W. State Street, Hartford, Wisconsin 53027 www.broan.com 800-558-1711
DUCT
CLAMP
DESCRIPTION
BROAN-NUTONE ONE YEAR LIMITED WARRANTY
USE AND CARE
WARNING: DISCONNECT ELECTRICAL POWER
SUPPLY AND LOCK OUT SERVICE PANEL BEFORE
CLEANING OR SERVICING THIS UNIT.
CLEANING
A continuously operating in-line ventilator needs to be
TAPE
cleaned once a year to assure proper performance.
OR
Remove cover and carefully vacuum blower and inside
of housing. Be careful not to bend or otherwise damage
blower wheel.
Diffusers and intake vents can be vacuumed and/or
wiped clean with a damp cloth.
MOTOR LUBRICATION
The motor is permanently lubricated. Do not oil or disas-
semble motor.
SERVICE PARTS
Models SP100, SP140 & SP200
99045429A