Basic Operation - DeFelsko PosiTector IRT Manual De Instrucciones

Press the
life, the gage will automatically go to sleep after 5 minutes of
inactivity. While in Sleep Mode, the gage powers up significantly
faster— convenient when moving between parts or locations. The
gage will completely power off after 4 hours of inactivity.
Alternatively, select Power Off from the main menu. All settings
are retained.
1. Remove the protective rubber cap from the probe.
2. Power-up Gage by pressing the center navigation
3. Verify emissivity setting and adjust if necessary (pg. 4).
The infrared temperature sensor immediately begins measuring.
Press the button to pause the measurement. Press
resume.
Surface
Temperature
Battery Indicator
Introduction
Introduction

Basic Operation

Basic Operation
button to power up the Gage. To conserve battery
Typical Display
1
button.
again to
Emissivity (pg. 4)
SmartTrend Indicator -
Appears when surface
temperature is rising or
falling. Does not appear
when measurement is
stable.
Temperature Unit