Philips QC5130/15 Manual De Usuario página 11

3 Slide the on/off slide upwards to switch on the appliance.
4 Move the hair thinning comb through the hair.
Make sure that the thinning comb only touches each spot once,
otherwise it cuts all the hair to the set hair length.
Creating a smooth transition between two hair lengths
If you have cut your hair to two different lengths, you can use the thinning
comb to create a smooth transition between these two lengths.
1 Slide the hair-thinning comb into the guiding grooves of the appliance
('click').
Make sure that you slide the arms of the comb properly into the grooves
on both sides.
2 Set the thinning comb to a hair length setting that is halfway between
the two hair length settings you used to create the haircut.
For instance, set the thinning comb to 15mm if you have cut the top part
of the haircut to a length of 20mm and the bottom part of the haircut to a
length of 10mm.
3 Move the thinning comb upwards through the transition between
the two lengths.
Make sure that the thinning comb only touches each spot once,
otherwise it cuts all the hair to the set hair length.
Cleaning
Keep the appliance and the adapter dry. Only clean the appliance and the
adapter with the cleaning brush supplied.
Never use compressed air, scouring pads, abrasive cleaning agents
or aggressive liquids such as alcohol, petrol or acetone to clean the
appliance.
Do not use any sharp objects to clean the appliance.
Clean the appliance after every use.
1 Make sure the appliance is switched off and disconnected from the
mains.
2 To remove the comb, press the length setting selector, move the
comb upwards and then pull it off the appliance. Clean the comb
with the cleaning brush supplied.
ENGLISH
11