Power Failure
•
Power failure -
If power to the appliance is
interrupted the System Status indicator will turn-off and
the "Power Failure" indicator will flash. Additionally, an
"ALARM RESET" indicator will be displayed below the
"On/Off" keypad. No audible tone will sound. This
alarm condition can be reset by momentarily pressing
the "On/Off" keypad. If this alarm occurs, it is
recommended that you check the condition of any
perishables, even if the appliance is operating normally
and the temperature has recovered, as prolonged
power outages could result in excessive temperature
excursions which may spoil perishables.
Temp
•
Temperature alarm -
temperature deviates excessively from your set-point
temperature for an extended period of time, the
"TEMP" indicator will flash, and an audible tone will
sound every 60 seconds. Additionally, an "ALARM
RESET" indicator will be displayed below the "ON/
OFF" keypad.
NOTE
After a high temperature alarm condition, check all
perishables to ensure they are safe for consumption.
NOTE
The temperature alarm may occur as a result of high usage
or introduction of warm contents to the storage
compartment. If the temperature alarm continues to occur,
your unit may require service.
NOTE
The audible alarm can be muted, for each occurrence, by
pressing the lock keypad.
This alarm condition can be reset by momentarily pressing
the "On/Off" keypad. If this alarm occurs it is recommended
that you check the condition of your stored contents, even
though the appliance is operating normally and the
USING YOUR ELECTRONIC CONTROL
ALARM RESET
ALARM RESET
If the storage compartment
temperature has recovered, as prolonged temperature
excursions could spoil perishables.
NOTE
Multiple alarms are possible, i.e.- "Door Ajar" for a
prolonged period may trigger a "Temp" alarm, in which
case both "Door Ajar" and "Temp" indicators will activate.
Vacation mode (Single and Dual Zone):
This operating mode can be used to save energy during
high cost energy periods, or when you won't be using your
appliance for an extended period of time by disabling the
lights, alarm tones, and keypad entry tones. Vacation
mode also serves as a Sabbath mode, disabling functions
and its controls in accordance with the weekly Sabbath and
religious holidays observed within the Orthodox Jewish
community. When used as Sabbath mode, you may open
or close the door at any time to access contents without
concern of directly turning on or off any lights, digital
readouts, solenoids, fans, valves, compressor, icons,
tones, or alarms.
When activated, the display, alarm indicators and tones,
keypad touch tones, interior lights, and all options are
disabled. All keypad functions are disabled, with the
exception of the "On/Off" keypad which is required to exit
Vacationmode. Storage compartment temperatures are
monitored and controlled at the settings prior to entering
Vacation mode.
To enter Vacation Mode (with the control out of sleep
mode), press and hold the "On/Off" keypad until the display
goes past "OFF" and reads "VAC". The display will flash
"VAC" 3-times to acknowledge your request, then will
display "VAC" continuously until Vacation mode is exited. A
power outage will not exit Vacation mode, exiting can only
be accomplished manually. To exit Vacation mode and
return to normal operation, press and hold the "On/Off"
keypad until the control displays the temperature.
15
Door Ajar
Temp