Installing; Electrical Shock Hazard; Electrical Connection - AGA marvel ML15WSG2 Serie Instrucciones De Instalación, Operación Y Mantenimiento

avoid scratching the floor. With the assistance of
another person, lean the appliance back to access the
front leveling legs. Raise or lower the legs to the
required dimension by turning the legs. Repeat this
process for the rear by tilting the appliance forward
using caution. On a level surface check the appliance
for levelness and adjust accordingly.
The front grille screws may be loosened and the grille
adjusted to the desired height. When adjustment is
complete tighten the two front grille screws. (See Figure
5).
Figure 3
• Do not use an adapter. See Figure 4).
• Do not splash or spray water from a hose on the appliance. Doing so may cause an electrical
dance with the National Electrical Code and applicable local codes and ordinances (see Figure 6). If the
circuit does not have a grounding type receptacle, it is the responsibility and obligation of the customer to
provide the proper power supply. The third ground prong should not, under any circumstances, be cut or
removed.
INSTALLING YOUR APPLIANCE

Electrical Shock Hazard

Do not remove • Do not use an extension cord with this appliance. ground prong They can be
•
This appliance should not, under any circumstances, be installed to an un-
grounded electrical supply.
•
Do not remove the grounding prong from the power
shock, which may result in severe injury or death.
A grounded 115 volt, 15 amp dedicated circuit is required.
This product is factory equipped with a power supply cord that has a
three-pronged, grounded plug. It must be
Figure 4
Model Door Style
ML(15)(24)* (S) or (G)
ML(15)(24)* (P) or (F)
!
hazardous and can degrade product
performance.
cord. (See Figure 3).

Electrical Connection

plugged into a mating grounding type receptacle in accor-
5
Minimum
Height
⁄
33 "
3
4
(85.7 cm)
34"
(86.4 cm)
Table A
WARNING
Maximum
Height
⁄
34 "
3
4
(88.3 cm)
35"
(88.9 cm)