Procedure In The Event Of Malfunction; Overvoltage; Overheating; Overloading - vitra. Tyde 2 Instrucciones Para El Uso

Procedure in the event of malfunction

EN
! CAUTION!
odours, unusual noises, other faults or operational failures, switch off the
power supply immediately and contact your Vitra retail partner.

Overvoltage

! DANGER!
overvoltage:
ƒ Keep the power supply switched off during installation and
maintenance work.
ƒ Switch off the power supply if the unit begins to emit smoke, odours or
unusual noises.
ƒ Switch off the power supply in case of storms and before leaving the
unit unattended for extended periods.
ƒDo not pour any liquid/splash water into or onto the plug connections.
ƒDo not operate the unit if the power cable is damaged. Ensure
damaged power cables are replaced by Vitra Service or by a qualified
electrician.
ƒObserve Vitra general electrification notice. 710 254 24.

Overheating

! CAUTION!
To avoid the risk of injury caused by overheating:
ƒafter the table has been switched on for a maximum of 2 minutes, do not
activate it again for at least 18 minutes.
ƒImmediately give the table a break of at least 18 minutes when there is a
reduction in speed, as this indicates that the table is beginning to overheat.
16
In case of malfunctions, e.g. emission of smoke or
To avoid the risk of injury caused by mains-related

Overloading

! ATTENTION!
The table columns will
work best when the load on the table is
distributed evenly:
ƒ max. 2 x 25 kg at the edges
ƒ max. 50 kg total area evenly distributed on
the tabletop
max.
max.
25 kg 25 kg
55 lbs 55 lbs

Noise emission

The noise emission during use is
max. 50 dB(A).

Movement range

65 - 125 cm