Reset; Unit Of Measurement Cm/Inch Change; Troubleshooting - vitra. Tyde 2 Instrucciones Para El Uso

Reset/perform
! CAUTION! Risk of injury around the columns during

reset

ƒKeep your distance from the table when adjusting the
height.
ƒDo not place any items under the table when adjusting the
height.
Move your table downwards. Your table will stop automati-
cally just before the end position. (Table height 65 mm)Move
your table down again.
Once it has reached the end position (table height 64 mm),
the table will automatically shift back up slightly. The reset is
performed automatically.
If you remove your hand from the handset before the reset
has been carried out, the reset is interrupted and you must
repeat the procedure.
You will not be able to move your table up if the reset proce-
dure has been interrupted.
Reset/to factory settings
When you reset to factory settings, your DPG is returned to
its configurable state. This means that not all configurations
made in the DPG configurator will be reset, but only the set-
tings that were changed directly on the DPG (or in the app).
Press at the same time for 8 seconds
After 5 seconds, the display will light up and show an arrow
with a countdown.
The light bar will flash red three times when the reset is com-
plete.
(DPG1C02-000006)

Unit of measurement cm/inch change

If the height shown on the display is not correct, it can be
adjusted.
Press at the same time for 5 seconds
-display height flashes and
displays cm or inch
Press the handset once to change the unit.
Press any button to confirm the height or wait 10 seconds.
Confirmation is automatic.

Troubleshooting

Errors Cause
Motor,
control sys-
Bad plug contact
tem,
Motor faulty
telescopic
Control system
guides
faulty
or
Handset faulty
handset
Feed cable faulty
does
not work.
Your
table
cannot Power failure
move
up/down.
(DPG1C02-000006)
EN
Solution
Contact your Vitra
retail partner.
1. Unplug the power
cable for 1-2 seconds.
2. Reset the unit.
21