Bosch GOP 12V-28 Professional Manual Original página 18

18 | English
Application tool
Sanding plate for
Delta series 93 mm
sanding sheets
Profile sander
Bi-metal plunge cut
saw blade for wood
and metal
HCS plunge cut
saw blade for wood
Bi-metal plunge cut
saw blade for hard-
wood
TC plunge cut saw
blade, metal
Bi-metal plunge cut
saw blade for wood
and metal
TC-Riff segment
saw blade
Diamond-Riff seg-
ment saw blade
TC-Riff Delta plate Mortar, concrete residue,
TC-Riff grout and
mortar remover
1 609 92A 4A6 | (11.06.2018)
Material Application
Depends on the sanding Sanding surfaces at edges, in corners or in difficult-to-
sheet reach areas;
depending on the sanding sheet, e.g. for sanding wood,
paint, varnish, stone;
fleeces for cleaning and for texturing wood, removing rust
from metal and for keying varnish, polishing felt for pre-
polishing
Wood, pipes/profiles, Convenient and efficient sanding of profiles up to a dia-
paint, varnish, filler, metal meter of 55 mm;
red sanding sheets for sanding wood, pipes/profiles, var-
nish, filler and metal
Softwood, soft plastics, Small separating cuts and plunge cuts;
plasterboard, thin-walled example: Cutting a recess for sockets, cutting a copper
aluminium profiles and pipe so that it is flush with a surface, making plunge cuts in
non-ferrous metal pro- plasterboard
files, thin sheet metal,
Delicate adaptation work in wood;
non-hardened nails and
example: Sawing recesses for locks and fittings
screws
Wood-based materials, Separating cuts and plunge saw cuts;
soft plastics including sawing close to edges, in corners and in difficult-
to-reach areas;
example: Thin plunge cut in solid wood for installing a
ventilation grille
Hardwood, laminated Plunge cuts in laminated boards or hardwood;
boards example: Installation of skylights
Metal, extremely abrasive Plunge cuts in extremely abrasive materials or metal;
materials, fibreglass, plas- example: Cutting kitchen front covers, easy cutting
terboard, cement-bonded through hardened screws, nails and stainless steel
fibreboard
Softwood, hardwood, Plunge cuts in laminated boards or hardwood;
veneered boards, plastic- example: Shortening door frames, recesses for a shelf
coated boards, non-
hardened nails and
screws
Cement joints, soft wall Making cuts near edges, in corners or in difficult-to-reach
tiles, fibreglass-reinforced areas;
plastics, porous concrete example: Removing joints between wall tiles for improve-
ment work, cutting recesses in tiles, plasterboard or
plastics
Cement joints, soft wall Precise routing and cutting of tile/joint material, epoxy
tiles, epoxy resin, fibre- resin and fibreglass-reinforced plastics;
glass-reinforced plastics example: Producing small cut-outs in soft wall tiles and
routing recesses in fibreglass-reinforced plastic
Rasping and sanding on a hard surface;
wood, abrasive materials example: Removing mortar or tile adhesive (e.g. when re-
placing damaged tiles), removing carpet adhesive residue
Mortar, joints, epoxy Routing and cutting of joint material and tile material, as
resin, fibreglass-rein- well as rasping and sanding on a hard surface;
forced plastics, abrasive example: Removing tile adhesive and joint mortar
materials
Bosch Power Tools