Uline OHAUS SCOUT H-5848 Manual De Instrucciones página 11

CAUTION! Electric shock hazard. Disconnect
equipment from the power supply before
cleaning.
OPERATING ISSUE
Cannot turn on.
Poor accuracy.
Cannot calibrate.
Err 8.1
Err 8.2
Err 8.3
Err 8.4
Err 8.5
Err 8.6
rEf.Err
Lo.rEf
CAL E
USB.Err
If the troubleshooting section does not resolve your problem, contact Uline Customer Service at 1-800-295-5510.
PAGE 11 OF 33
MAINTENANCE
TROUBLESHOOTING
No power to balance. Bad power source. AC adapter or batteries. Faulty keypad.
Improper calibration; Unstable environment.
Security switch in locked position.
Weight exceeds power on zero range.
Weight below power on zero range.
Overload (weight exceeds rated capacity).
Under load (platform removed).
Tare out of range.
Displayed value exceeds 999999 (possible in totalization mode).
Parts counting or percentage error – sample weight <1d. Balance shows error then
exits parts counting or goes to
Percent Reference weight or APW is too low for accurate results.
Fail to do calibration.
Cannot find menu or application file in U-disk.
1-800-295-5510
CAUTION! Do not use solvents, chemicals,
alcohol, ammonia or abrasives to clean the
housing or control panel.
1. Clean the housing with a damp cloth and mild
detergent, if necessary.
POSSIBLE CAUSE
Clr.APU.
uline.com
0521 IH-5848