Uline OHAUS SCOUT H-5848 Manual De Instrucciones página 2

DISPLAY
DISPLAY SYMBOLS
#
1
2
3
4
5
6
7
• Verify that local AC power supply is within input
voltage range printed on AC adapter's data label.
• Only connect AC adapter to a compatible
grounded electrical outlet.
• Do not position scale where difficult to disconnect
AC adapter from power receptacle.
• Make sure that power cord does not pose a
potential obstacle or tripping hazard.
• For indoor use. Operate only in dry locations.
RELEASING THE TRANSPORTATION LOCK
1. Release the red transportation lock on the
subplatform of the balance by turning the red
pointer 90° counterclockwise. (See Figure 1)
Subplatform
Transportation
PAGE 2 OF 33
OVERVIEW OF CONTROLS CONTINUED
1
2
3
4
5
6
7
DESCRIPTION
Battery Charge Symbol
Stable Weight Symbol
Negative Symbol
Center of Zero Symbol
NET Symbol
Preset Tare, Tare Symbols
Pointer Symbols
NOTE: Some symbols might not be available, depending on model.
Lock Pointer
Locked
Position
Unlocked
Position
# DESCRIPTION
8 Kilogram, Grain Symbols
9 Check Weighing Symbols
10 Pound, Ounce, Pound:Ounce Symbols
11 Percent, dwt, g/mol symbols
12 Gravity, Pieces, t hk, t sg, t tw, Hold Symbols
13 Newton, Totalization, Dynamic, Bluetooth Symbols
SAFETY
• Operate only under ambient conditions specified in
these instructions.
• Do not operate in hazardous or unstable
environments.
• Do not drop weight onto pan.
• Only use approved accessories and peripherals.
• Disconnect power before cleaning or servicing.
• Service should be performed only by authorized
personnel.
SETUP
INSTALLING THE PLATFORM
1. Balances with a rectangular platform are placed
into the subplatform as shown and rotated
counterclockwise until locked. (See Figure 2)
2. Round platforms are placed straight down on
subplatform. (See Figure 3)
Figure 1
13
12
11
g/mol
10
9
8
Figure 2 Figure 3
0521 IH-5848