D-Link DWC-2000 Guia De Instalacion página 5

Step 2 – Installation
You can mount the DWC-2000 into a standard
19-inch equipment
DWC-2000 into a rack:
1. Attach the mounting brackets to each side
of the chassis as shown in Figure 5 and
secure them with the screws provided.
Figure 5. Mounting Brackets
2. Use the screws provided with the equipment
rack to mount the device in the rack as
shown in Figure 6.
Figure 6. Mount into the Rack
Step 3 – Connecting the Device
to a Network
This section provides basic information about
physically connecting the DWC-2000 to a
network.
Connect the necessary cables as shown in
Figure 7.
rack. To install the
Figure 7. Connecting to Your Network
1. Connect an RJ-45 cable from one of the
ports labelled LAN (1-4) to a switch in the
LAN network segment.
2. Connect an RJ-45 to DB-9 cable from the
console port to a workstation to use the CLI
(Command Line Interface) for management.
Step 4 – Powering on the Device
The AC power cord shipped with the device
connects the device to earth ground when
plugged into a grounded AC power outlet.
The device must be grounded during normal
operation.
To connect the device to a power source, plug
one end of the AC power cord into the AC power
connector on the back panel of the device. Plug
the other end into an electrical outlet and switch
ON the power switch.
Note: We recommend using a surge protector
for the power connection.
3