OTHER CONSIDERATIONS
Install any extra grab bars or towel bars through module
walls, and fasten in place directly to bridging previously
installed. Select screws, bolts, and backing to properly
secure the accessories. Carefully seal around the
accessory fastener surfaces. Follow all manufacturer's
instructions.
CLEAN-UP AFTER INSTALLATION
When cleaning up after installation, use warm water and an
approved liquid cleanser to clean the surface.
CAUTION: Risk of product damage. Do not use
abrasive cleansers.
Stubborn stains, paint, or tar can be removed with turpentine
or paint thinner.
CAUTION: Risk of product damage. Do not allow
cleaners containing petroleum distillates to remain in
contact with module surfaces for any length of time.
Plaster can be removed by scraping with a wood edge. Do
not use metal scrapers, wire brushes, or other metal tools.
Use warm water and an approved liquid cleanser to provide
mild abrasive action to remove residual plaster.
Kohler Co., Kohler, WI U.S.A.
5
A
1010414-2-