Pro-Lift W-1706 Instrucciones De Funcionamiento Y Manual De Partes página 3

Figure 2
Quick Connector
Adapters for Inflatables
Hose
4. Insert power cord into a suitable outlet or 12V DC source
(Fig. 4). Toggle air ON/OFF switch to ON position. Unit
should begin inflating.
5. Compressor will inflate tire (or other inflatable) to the
preset pressure, then automatically shut off.
6. Toggle air ON/OFF switch to OFF, disconnect Quick
Connector and unplug the compressor power cord.
7. Use a tire gauge to check inflation and adjust to desired
pressure as recommended by the vehicle and/or tire
manufacturer.
Figure 3
Figure 4
Sports Adapter
Plastic air hose
inflator adapters
Figure 5
NOTICE: If tire is at higher pressure than value set on
gauge, compressor will not start.
NOTICE: Do not rotate gauge dial during inflation.
NOTICE: Always double check air pressure using a reli-
able pressure gauge.
B. For use with low pressure inflatables
NOTICE: The automatic shut-off feature does not function
on low pressure inflatables.
1. To inflate air mattresses, beach balls, life jackets, etc.,
remove plastic air hose and air hose inflator adapters
from storage compartment.
2. Insert plastic air hose inflator adapter into low pressure
inflater outlet (labeled "OUT") in front of compressor,
and use to connect plastic air hose.
3. At opposite end of hose, connect suitable adapter for
inflatable (Fig. 5) and insert into appropriate receiver in
inflatable.
4. Plug the compressor into the DC 12V outlet. Toggle air
ON/OFF switch to ON position. Unit should begin inflat-
ing.
5. Inflate to a pressure or level of firmness recommended
by the manufacturer. Toggle air ON/OFF switch to OFF
and check for desired firmness or pressure as needed.
6. Remove plastic hose adapter from inflatable.
7. Remove the adapter from plastic hose.
C. DEFLATING INFLATABLES
1. To deflate air mattresses, beach balls, life jackets, etc.,
remove plastic hose and plastic air hose adapters from
storage compartment.
2. Insert plastic hose inflator adapter into low pressure
deflator outlet in front of compressor (labeled "IN") and
connect plastic hose.
3. At other end of hose, select and insert suitable adapter
(Fig. 5).
4. Insert the adapter into the appropriate receiver on the
item to be deflated.
5. Connect the 12V DC plug to a suitable power source and
toggle the ON/OFF switch to ON. Compressor should
begin deflation.
6. When item is sufficiently deflated, toggle ON/OFF switch
to OFF.
7. Remove plastic hose from deflated item, remove adapter
from plastic hose and place them in storage compart-
ment.
D. OPERATING THE WORK LIGHT
1. Plug the compressor into a suitable 12V DC power
source. Toggle light ON/OFF switch to ON position.
2. Toggle switch to OFF position to extinguish light.
3