Product-Specific Safety Instructions; Description; Mounting Instructions - Heru VT 55 Instrucciones De Uso

Product Specific
Safety Instructions
• Place the appliance on a flat and dry
surface.
Danger of serious injuries!
• Never operate the fan without the
guards installed.
• While the fan is in operation
• Never reach through the grid with
your hands.
• Never put any objects, such as pens,
through the grid.
• Never attempt to stops the blades
with your hands.

Description

1 Front guard
2 Screw cap
3 Blades
4 Rear guard mounting nut
5 Rear guard
6 Motor shaft
7 Motor unit
8 Oscillation knob
9 Tilt adjusting screw
10 Buttons
11 Buttons compartment
12 Mounting screw
13 Extension pole
14 Height adjustment ring
15 Pole
16 Cross base cover
17 Cross base
GB

Mounting Instructions

Attention! Do not connect the
appliance to the mains until
fully mounted.
1. Attach the pole (15) to the hub of the
cross base (17) and firmly tighten with
the screws provided. Slide the cross
base cover (16) over the pole (15).
2. Extend extension pole (13) and insert
the height adjustment ring (14) through
the extension pole (13) onto the lower
pole (15) and tighten.
3. Attach the motor unit (7) with the button
compartment (11) onto the extension
pole (13). Make sure the button com-
partment (11) is fully pushed down onto
the pole and tighten with the mounting
screw (12).
4. Loosen rear guard mounting nut (4)
from the motor unit (7).
5. Put rear guard (5) into place onto motor
shaft (6). Secure guard by firmly tight-
ening mounting nut (4).
6. Slide the fan blade (3) onto the motor
shaft (6). Fasten it firmly with spinner
cap (2) by turning counter-clockwise.
7. Attach the front guard (1) to the rear
guard (5) with the position fixer pro-
vided at the rim of the guard. Then fix
both guards with the clips provided.
Attention! Make sure that all
parts are assembled correctly
and firmly tightened.
-8-