Technical Specifications; Control Panel - HoMedics AT-PET02 Manual Del Usuario

Technical Specifications

NOTE: This appliance has a polarized plug (one blade is wider than
the other). To reduce the risk of shock, this plug is intended to fit only
one way in a polarized outlet. If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit, contact a qualified electrician.
DO NOT attempt to defeat this safety feature. To do so could result in
an electric shock hazard.

Control Panel

Replace Odor
Filter/Reset
Fan Speed
Power On/Off
Replace HEPA
FIlter/Reset
Oscillation
On/Off
6
Operating Instructions
Turning the Unit On
• Take the air purifier out of the box and remove the clear protective plastic bag.
• Place the air purifier on a firm level surface.
• Make sure the air purifier is off and unplugged to confirm that the filters are firmly
in place and did not become loose during shipping.
Timer
Fig. 3
Fig. 5
NOTE: Unit will not operate unless filters and grill cover are properly installed.
1. To check filters, open the rear cover by
gently pushing down on the release tab on
the top of the rear grill cover. Fig. 1
2. Open the grill cover outward until the tabs
at the bottom of the grill cover easily slide
away from the unit. Fig. 2
Fig. 1
3. The True HEPA filters will be resting
inside the unit. Make sure the filters are
firmly seated inside of the unit. Fig. 3
4. Locate the PetPlus Odor Filters in the rear
grill cover. Remove the PetPlus filters from
Fig. 2
the plastic bags they are shipped in and set
aside. Check to make sure the Pre-Filter is
Fig. 4
seated in place on the frame of the grill cover
(Fig. 4). Then, place the PetPlus Odor Filters
into the rear grill cover, seating them on the
rails, with the pull tabs facing outward at the
top of each filter. Fig. 5
5. Place the tabs at the bottom of the grill
cover into the base of the unit. Gently push
the grill cover back into place until you hear
a click sound indicating that the grill cover is
firmly latched. Fig. 6
Connect the power cord into a
standard AC outlet.
Fig. 6
7