Kobalt 0054849 Manual Del Usario página 9

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY INSTRUCTIONS
9. Screw one end of wall strap (EE) to
the top back panel (A) with
#8-32 x 3/8 in. bolts (BB) and #8-32
nuts (CC). Secure the other end to the
wall with ST4 x 20 mm screws (DD).
Note: This cabinet should be anchored to the
wall using the wall strap (EE) to avoid any
potential danger from cabinet falling. Check and
see if the top (D) is level. If not level due to
uneven floor, the two doors will probably not be
properly aligned. In this case, use an adjustable
wrench (not included) to adjust the hex nut until
the top (D) is level.
Hardware Used
#8-32 x 3/8 in. Bolt
BB
#8-32 Nut
CC
ST4 x 20 mm
DD
Screw
10. OPTIONAL
To install the unit to the wall without a
®
K-Rail
, follow the below step.
Otherwise proceed to optional K-Rail
mounting instructions on the next page.
Move the unit to the wall, making sure
the back of the unit is flush with the
wall. Feed the ST4.8 x 100 mm pan
head screws (HH) through the 5 x 15 x
1.2 mm washers (II) and top back panel
(A). Screw the ST4.8 x 100 mm pan
head screws into wall studs, and
tighten securely.
Note: Screws must be placed into wall studs.
The unit will not be secured if screwed into
drywall. If there is a gap between the unit and
the wall due to moulding on the garage floor,
please make the unit press against the
moulding and be parallel to the wall.
Hardware Used
ST4.8 x 100 mm Pan
HH
head screws
9
x 2
x 2
x 2
EE
Wall strap
10
®
II
x 2
II
9
D
A
CC
A
Wall
HH
5 x 15 x 1.2 mm
Washer
Lowes.com
EE
Wall
EE
DD
BB
x 1
x 2

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido